blob: 3d185ba8003a3dbed0d5b3fc28a827cc54eabfc4 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
|
Hello,
I'm not sure about the differences and interactions between watch / assistant / webapp / direct mode. I think I figured the following out, can someone confirm this, and perhaps a few words to the documentation / man page?
- git annex watch uses inotify to find new files, and runs git annex add on them (it does not do regular git add)
- git annex assistant does the same as watch, but also runs git annex sync for each new file (does it also enable direct mode?)
- git annex webapp does the same as assistant, and also starts a webapp (in my case it immediately started sending files to origin, without asking for confirmation, which was surprising, I guess this is because I have * annex.numcopies=2 set, and there was only one copy. Still I interpreted the documentation as if it would only show me an interface, not start doing things right away.)
Do these commands do anything else than what I described above?
best regards,
Tom
|
