git-annex (5.20131127) unstable; urgency=low

  * webapp: Detect when upgrades are available, and upgrade if the user
    desires.
    (Only when git-annex is installed using the prebuilt binaries
    from git-annex upstream, not from eg Debian.)
  * assistant: Detect when the git-annex binary is modified or replaced,
    and either prompt the user to restart the program, or automatically
    restart it.
  * annex.autoupgrade configures both the above upgrade behaviors.
  * Added support for quvi 0.9. Slightly suboptimal due to limitations in its
    interface compared with the old version.
  * Bug fix: annex.version did not get set on automatic upgrade to v5 direct
    mode repo, so the upgrade was performed repeatedly, slowing commands down.
  * webapp: Fix bug that broke switching between local repositories
    that use the new guarded direct mode.
  * Android: Fix stripping of the git-annex binary.
  * Android: Make terminal app show git-annex version number.
  * Android: Re-enable XMPP support.
  * reinject: Allow to be used in direct mode.
  * Futher improvements to git repo repair. Has now been tested in tens
    of thousands of intentionally damaged repos, and successfully
    repaired them all.
  * Allow use of --unused in bare repository.

# imported from the archive

1 files changed, 19 insertions, 0 deletions

diff --git a/doc/bugs/Is_there_any_way_to_rate_limit_uploads_to_an_S3_backend__63__.mdwn b/doc/bugs/Is_there_any_way_to_rate_limit_uploads_to_an_S3_backend__63__.mdwn
new file mode 100644
index 000000000..64826c02a
--- /dev/null
+++ b/doc/bugs/Is_there_any_way_to_rate_limit_uploads_to_an_S3_backend__63__.mdwn
@@ -0,0 +1,19 @@
+What steps will reproduce the problem?
+
+Adding files to a local annex set up to sync to a remote S3 one
+
+
+What is the expected output? What do you see instead?
+
+It syncs, but maxes out the uplink
+
+
+What version of git-annex are you using? On what operating system?
+
+3.20121112 on Debian testing
+
+
+Please provide any additional information below.
+
+The man page lists how to configure rate limiting for rsync, not sure how to do it for this
+