\section switch switch - conditionally execute a block of commands \subsection switch-synopsis Synopsis switch VALUE; [case [WILDCARD...]; [COMMANDS...]; ...] end \subsection switch-description Description The \c switch statement is used to perform one of several blocks of commands depending on whether a specified value equals one of several wildcarded values. The \c case statement is used together with the \c switch statement in order to determine which block should be performed. Each \c case command is given one or more parameter. The first \c case command with a parameter that matches the string specified in the switch command will be evaluated. \c case parameters may contain wildcards. These need to be escaped or quoted in order to avoid regular wildcard expansion using filenames. Note that fish does not fall through on case statements. Though the syntax may look a bit like C switch statements, it behaves more like the case stamantes of traditional shells. Also note that command substitutions in a case statement will be evaluated even if it's body is not taken. This may seem counterintuitive at first, but it is unavoidable, since it would be impossible to know if a case command will evaluate to true before all forms of parameter expansion have been performed for the case command. \subsection switch-example Example If the variable \$animal contains the name of an animal, the following code would attempt to classify it:
switch $animal
    case cat
        echo evil
    case wolf dog human moose dolphin whale
        echo mammal
    case duck goose albatross
        echo bird
    case shark trout stingray
        echo fish
    case '*'
        echo I have no idea what a $animal is
end
If the above code was run with \c \$animal set to \c whale, the output would be \c mammal.