1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
|
Debugging from Coq toplevel using Caml trace mechanism
======================================================
1. Launch bytecode version of Coq (coqtop.byte or coqtop -byte)
2. Access Ocaml toplevel using vernacular command 'Drop.'
3. Install load paths and pretty printers for terms, idents, ... using
Ocaml command '#use "base_include";;' (use '#use "include";;' for a rawer
term pretty printer)
4. Use #trace to tell which function(s) to trace
5. Go back to Coq toplevel with 'go();;'
6. Test your Coq command and observe the result of tracing your functions
7. Freely switch from Coq to Ocaml toplevels with 'Drop.' and 'go();;'
Hints: To remove high-level pretty-printing features (coercions,
notations, ...), use "Set Printing All". It will affect the #trace
printers too.
Debugging from Caml debugger
============================
Needs tuareg mode in Emacs
Coq must be configured with -debug and -local (./configure -debug -local)
1. M-x camldebug
2. give the binary name bin/coqtop.byte
3. give ../dev/ocamldebug-coq
4. source db (to get pretty-printers)
5. add breakpoints with C-x C-a C-b from the buffer displaying the ocaml
source
6. get more help from ocamldebug manual
run
step
back
start
next
last
print x (abbreviated into p x)
...
7. some hints:
- To debug a failure/error/anomaly, add a breakpoint in
Vernac.vernac_com at the with clause of the "try ... interp com
with ..." block, then go "back" a few steps to find where the
failure/error/anomaly has been raised
- Alternatively, for an error or an anomaly, add breakpoints in the middle
of each of error* functions or anomaly* functions in lib/util.ml
- If "source db" fails, recompile printers.cma with
"make dev/printers.cma" and try again
Global gprof-based profiling
============================
Coq must be configured with option -profile
1. Run native Coq which must end normally (use Quit or option -batch)
2. gprof ./coqtop gmon.out
Per function profiling
======================
1. To profile function foo in file bar.ml, add the following lines, just
after the definition of the function:
let fookey = Profile.declare_profile "foo";;
let foo a b c = Profile.profile3 fookey foo a b c;;
where foo is assumed to have three arguments (adapt using
Profile.profile1, Profile. profile2, etc).
This has the effect to cumulate the time passed in foo under a
line of name "foo" which is displayed at the time coqtop exits.
|
